The RulerWrap for Microsoft Surface Pen
An ultra-thin transparent skin that converts your Surface Pen into a convenient measuring tool.
✓ Converts your stylus into a convenient measuring device, great for creatives on the go.
✓ Optimizes your work flow. Useful for reverse engineering, product design, 3D modeling, 3D printing, and UX design.
✓ Improves the grip of your stylus for greater control and less accidental drops.
✓ Ultra-thin transparent vinyl skin eliminates wireless charging issues and premature peeling.
✓ 100% Made in Canada. Supporting local business and fair labor practices is important to us, as is providing the highest quality products possible.
Designed for the Microsoft Surface Pen with no clip. Access to stylus' battery is not impacted as the wrap is made of two separate pieces. May be compatible with other Surface Pens with some trimming of the wrap.
Haze Gray - IN STOCK
Stark White - IN STOCK
✓ High quality laser-cut vinyl for an accurate fit
✓ Quick and easy installation, no heat required vinyl
✓ Millimeter and inch units, inspired from precision measuring calipers
✓ Glossy transparent finish for a grippier surface and a stock look
✓ No adhesive residue left behind if removed
✓ Wide compatibility with many devices and styluses.
The RulerWrap adheres to the curved surface of the stylus leaving the flat surface uncovered to avoid interfering with its magnetic charging surface, and potential fitment issues.
Compatibility: Designed for Microsoft Surface Pen (with no clip). May fit other Surface Pens, but this remains untested. Confirm using dimensions below.
Dimensions: 24mm x 124mm
Color: clear / transparent
Thickness: 0.13 mm
Material: high-grip super gloss finish vinyl
Step 1 - Clean
Clean your stylus with a small amount of rubbing alcohol or water to remove any surface oils left from your hands.
Step 2 - Peel
Peel back one corner of the wrap and proceed to peel and fold the wrap's backing along the length of the wrap. Take your time here and do not touch the sticky side of the wrap.
Step 3 - Line 'em up
Visually line up both corners of the wrap slightly below the flat edge of the stylus. With both corners lined up correctly (but not touching yet), lightly stick one corner of the wrap so that it can still be pivoted without stretching it and lightly stick the second exposed corner.
Press the sticker with a downward pressure, slowly pressing along the length of the wrap in sections as you curl around the stylus. Disperse your finger pressure as much as possible to avoid stretching or deforming the wrap.
As you loop around your stylus, keep an eye out for air pockets and gently push them out as you go. Work in 3mm increments to ensure a clean install.
Once you've fully adhered the wrap to the stylus, do one final inspection of the wrap and ensure all air pockets are gone. We like to give one more pass on all corners and edges to ensure adhesion is optimal in areas that may experience the most friction.
And you're done, great job! Now enjoy your convenient measuring device and let us know how it is.